Monday, September 23, 2013

Press Release - Indecent Exposure Incidents


Below is a press release from the Milton Police Department regarding indecent exposure incidents that occurred on Friday, September 20th. 


At approximately 5 am on September 20th, an adult female was approached in the 400 block of Columbus St. in Milton by an adult male subject who pulled down his shorts and began masturbating while asking her a sexually suggestive question. After the male had this contact the female entered a building nearby and law enforcement was contacted. The subject was not in the vicinity when law enforcement arrived shortly thereafter. The adult female stated that the male subject was white, average build and height, early 20’s, wearing shorts and no shirt. No vehicle was seen. 

A short while later, at approximately 5:15 am, a white male in his early 20’s approximately 5’10”, average build with a dark colored t-shirt and no shorts or pants was observed by a female employee at a business located in the 100 block of Front St. in Milton. The subject was observed with his t-shirt pulled up over most of his face, with no clothing on below the waist, masturbating and staring in the window of the business. After the employee notified the owner, the adult male subject fled to a dark gray/gold colored, 90’s era pickup truck, with no cap over the rear bed, and fled the area last seen traveling west on Ansley Ave. Law enforcement arrived shortly after and no subject was located. 

The Milton Police Department is seeking the public’s assistance with identifying this subject and/or his vehicle. 

Individuals that come forward with information that leads to the arrest of the subject responsible for this crime are eligible for a cash reward through Janesville Area Crimestoppers. Individuals with tips can remain anonymous. If you have information regarding this incident please contact the Milton Police Department at 757-2244 or Janesville Area Crimestoppers at 756-3636. Anonymous tips can also be sent via text to CRIMES (274637), then enter JACS, plus your message.